Super Heavy Duty Flexible (won't just snap even if you hit the ground, unlike other aftermarket fingers) Reel Tine finger suits 1- 5/8"/ 42mm Tyne Bar Tube for -
Case IH draper fronts 2142, 2152, 2162
MacDon cutting platforms D50, D60, D70, D75, D225, D230, D235, D240, D241, D245, D250, FD70, FD75, FD130, FD135, FD140, FD145, FD230, FD235, FD240, FD241, FD245, FD250
New Holland draper fronts 82C, 83C, 86C
Quantity Required for Macdon
| |
20 Ft |
25 Ft |
30 Ft |
35 Ft |
40 Ft |
45 Ft |
| 5 Bat Reel |
191 Qty |
249 Qty |
280 Qty |
332 Qty |
384 Qty |
433 Qty |
| 6 Bat Reel |
231 Qty |
297 Qty |
336 Qty |
399 Qty |
462 Qty |
- |
| 9 Bat Reel |
348 Qty |
447 Qty |
504 Qty |
598 Qty |
- |
- |
Quantity Required for D2, FD2 Fronts
| Front - LH/RH/Center (Qty Per Reel Tube) |
Single Reel (Qty Per Reel Tube) |
| *Narrow |
^Wide |
*Narrow |
^Wide |
| FD230 - 40/41/0 |
FD230 - 37/38/0 |
FD225 - 70 |
FD225 - 71 |
| FD235 - 47/48/0 |
FD235 - 44/45/0 |
| FD240DR - 55/56/0 |
FD240DR - 51/52/0 |
| FD240TR - 40/41/26 |
FD240TR - 37/38/23 |
| FD241 - 56/57/0 |
FD241 - 52/54/0 |
| FD245 - 40/41/41 |
FD245 - 37/38/38 |
| FD250 - 47/48/41 |
FD250 - 44/45/38 |
*Narrow or wide tine tubes can be distinguished from the first three fingers of the RH side. Narrow tine tubes have one RH angled finger (MD #311523) followed by two straight fingers (MD #174849) and measure 76 mm, 146 mm, and 265 mm
^Wide tine tubes have two RH angled fingers (MD #311523) followed by one straight finger
(MD #174849) and measure 76 mm, 214 mm, and 315 mm
Cross Reference No: 84130300, 137987, 137627, 174849 (10 pack),174850, 84331097, 84331098, RT-987, RT987, 174850 (100 pack), WN-137987, WN-87561020, WN-137987-10, 174859, RF8512, 164434, 61020, A-174849, RT434, RT-434, RT007, RT018, CM137987
